PAPER-BACKED

Installation Guide

Tools Needed

Download Instruction Guide
Knife Pencil Scissors Measurement Tape Bucket Roller Spirit Level Ruler Sponge Wallpaper Paste (Power) Plastic Spatula
How does it work?
1. We recommend to have two people for this wallpaper installation.
2. Always inspect the wallpaper for defects before you proceed.
3. Never install the wallpaper over existing wallpaper.
4. Never pre-trim the wallpaper - Your wall or ceiling line may be slightly off.
5. Never start pasting process until the wall surface has been properly prepared,
all of the measurements have been double-checked and the necessary tools are on hand.
 
1
From the far end of your wall measure the width of panel #1.
 
2
Draw a straight line using a spirit level or plumb line. Make sure it is straight line as this will be the reference line for all the rest of wallpaper panels.
 
3
Apply paste to the back side of 1st panel. Take care to miss any areas.
 
4
Line the right hand edge of wallpaper (panel #1) to the line you have drawn. Wallpaper may have up to 1~2 inches bleed (extra image area) on each side of wallpaper panel. This overage is to accommodate irregular walls.
Do not trim this overage yet.
Using a clean damp sponge, gently press the panel against the wall, starting at the top. Smooth all wrinkles and bubbles outward, until they are removed. Professional installer prefer to use plastic spatula. Be careful, over pressure might hurt the surface of wallpaper.
CAUTION: Do not strecth the wallpaper while positioning.
 
5
Apply paste to panel #2. align panel #2 to panel #1. When matching panel #2 to panel #1, there will be a 0.5"~2" overlap. This is correct. Simply match the pattern of wall paper.
CAUTION: Do not install the panels with edges butt together.
 
6
Repeat Step 5 for the rest of panels. You will have overlaps all around.
 
7
When all panels have been adhered, trim any ceiling and baseboard overage, using your knife and plastic spatula.
CAUTION: Go slowly and change the blades often for the best result.
 
8
Double-cut overlapping seams. Place your ruler in the middle of the overlap and cut thru both layers. Peel away the outer piece of excess material. Now peel away the remaining excess material underneath the overlap. Smooth the panels back together, so the edges now butt together. A seam adhesive can be applied to keep panel edges from curling.
To remove any paste residue, wipe the mural, as well as the ceiling and baseboard molding, with a clean wet sponge.
We are looking for Baby & Kids Shop
We are looking for Interior Designer
We are looking for Photographer
We are looking for Furniture
We are looking for Curtain
We are looking for Wallpaper Reseller
We are looking for Photoshop
We are looking for Bridal House
We are looking for Francaise
We are looking for Chair Store
GENERAL INQUIRY : 016-445 3448 | CKFAN@STICKJOY.COM
About STICKJOY
 
 
About Murals
Inspiration
 
© 2014 STICKJOY